Background image
Learn To Build It
Startpage - Arduino - Connectivity


I will take a build out a few options like a network shield, WIFI adapters and a blue tooth adapters

Arduino Bluetooth connection with a Bluesmirf Gold
By: Steve Kerscher | Added: 4 April 2016 | Updated: 4 April 2016
| Rating: 0 | Pageviews: 1520
I take a Bluesmirf BlueTooth chip and connect it to my Arduino. Over all this is a very easy setup. Now it sounds like the two pins that are not used are for more complicated serial connects. Watch my video I explain that the directions say to put the RX and TX to the TX and RX ports on the arduino and the code is set up for 2 and 3. At this point I could not get it working at first because my Mac does not like connecting to it. But once I figure out that a fews trys ...
Arduino with networking shield sending data to website
By: Steve Kerscher | Added: 9 March 2016 | Updated: 9 March 2016
| Rating: 0 | Pageviews: 611
In this session I take a network shield and hook it to my Arduinio mega. I then take a temp sensor and a tilt switch and produce a webpage when a browser is pointed at the IP address of the Arduino.
Parts Needed
Make sure you set a correct IP address to match the ...
Page 1 of 1